3D Scanner Project Update 1

Our 3D scanner has always been a great machine, however, the difficulties in setup make it somewhat of a pain to use. To improve the capabilities, reliability, and ease of use of our scanner I looked to improve upon it somehow. I thought upgrading the sensor being used to a Kinect 2 would be an improvement but as it turns out the technology in the Kinect 2 changed and is no longer a viable solution to DIY scanning. After some investigating I found that the best (and only solution, if I’m honest) is to use a Structure Sensor from https://structure.io/. Luckily, we happened to already have one not in use so after validating it would work with our software I loaded up SolidWorks and began designing a new bracket to hold it in place. What I ended up with is this:



And after printing at 100% infill with PLA, the mount was ready to go.




No comments:

Post a Comment